Lanseutstyr

This Lance Holder has a very practical lever locking system acting on the sleeve and clamp. The pressure applied by the lever is adjustable by a ring. It has been designed for use in cases where large diameter (1" and over) lances are used, for which screw locking by-hand would be difficult. For higher safety, CONTESSI has recently introduced two new models of lance-holder with lever lock for 3/8" and 1/2" (BSP) lance diameters.

Swivel bracket for hose-reels 116,131,216,231 series

Oxygen Lance starter 1" (up to 38mm)

The pressure regulating boxes can be connected to the gas line at each point where Oxygen, fuel and inert gases. Pressure can be regulated for all purpose: brazing, oxy-cutting, heating or welding with shieldy gas. The protecting boxes are made entirely of stainless steel, with fixing holes and contain opening-closing valve, reducing valve with gauge, safety valve, for oxygen or fuel gases. odel Modello Media Fluido Operating pressure Pressione di esercizio Max flow Portata max Code Codice bar Nm3/h PPO/23 oxygen ossigeno 1,5÷15 40÷300 0640-105838 PPG/23 fuel gas gas combustibile 0,8÷6 25÷120 0640-105828

Suitable for the use with Oxygen. On request available for different gas. Inlet connection for cylinder. Outlet threaded connection 3/8" or 1/2" BSP male, on request.

Made of galvanized steel, protects the hose from the risk of accidental damage, dust and exposure to heat and radiation.

Valve for medium flow rates; it is fitted with a non-return valve, sintered filter and thermal device to shut-off oxygen in case of backfire or slag return.